Lyman Pistol Bullet Mould: 9mm Hollow Point – #356637 2650637
$157.75
Available on backorder
Shooting targets with your .9mm semi-automatic pistol can be quite a challenge. One solution to solve this dilemma is to turn to a top-quality pistol bullet mold. By using a top-quality mold like the Lyman Devastator 9mm 124 grain Round Nose Hollow Point Mold, you can produce a highly accurate bullet that is also a huge crowd pleaser. This mold was created by using a heat treatable steel that is precision ground to ensure a smooth release of the bullet from the mold. It also uses a steel sprue plate that has been ground flat and a spring-loaded sprue tower for a highly efficient and durable design.Reloading these moulds is half the time it takes to break the mould in versus those made from iron which is typical of cast molds. Also, the sprue plate uses spring-loaded screws and tempered steel causing no movement or change of sprue plate is needed. Using heat treated steel, the mold is incredibly reliable and is guaranteed to be long lasting.For a top quality way to create and create your own bullets look no further than the Lyman Pistol Bullet Mould – 9mm 124 grain. Specifications for Lyman Pistol Bullet Mould: 9mm Hollow Point – #356637 2650637: Manufacturer: Lyman Cartridge: 9mm Luger Fabric/Material: Steel Bullet Weight: 124 grain Bullet Type: Hollow Point (HP) Package Contents: Lyman Pistol Bullet Mould: 9mm Hollow Point – #356637 2650637
JDT –
Lyman Pistol Bullet Mould: 9mm Hollow Point – #356637 CASTS A VERY NICE HOLLOW POINT PLUS IT WORKS GREAT IN 38 SPECIAL ,SPRAY IT WITH LYMAN DROP-OUT LUBE AND ITS GOOD TO GO, I DO NOT KNOW WHAT ELSE I CAN SAY IF YOU WANT TO CAST A GOOD BULLET FOR 9MM OR 38SPECIAL THIS WOULD BE IT.
Steve –
For a single cavity mold this one is a bit heavy. Once it is warmed up it turns out some nice bullets. I get some casting done & my arm gets tired, so it is time to quit casting for a while. Mold should last forever.
Justin –
The two cavities are not concentric, which is so bad that my sizing die only touches half the bullet. The hollow point pin goes too deep into the bullet, causing a hair lip because the shoulder of the pin goes into the bullet. I sent the mold into Lyman for repair – they cross-threaded the handle screws, galled the screw head, and did not repair the eccentric cavities. I was told that replacement screws would be shipped to me but this never happened. Horrible quality and worse customer support. Get a high quality four cavity brass hollow point mold from MP Molds for nearly the same price as this single cavity piece of garbage.